We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
My basement shop is quite small and my drill press is right next to my workbench. When I needed to drill a long board, I would stack pieces of wood on top of my workbench to act as a support.
I decided to build a holder to sit on my workbench that would allow me to vary its height more accurately and easily than a stack of wood. It is 15″ tall and adjustable from 7″ to 14″. The stabilizing legs ensure that it won’t tip over.
I routed a slot in the center post, attached a small table with a support block to a plywood backer board, and drilled a hole for a carriage bolt that goes through the plywood backer board and the slot. A T-knob tightens the bolt at the right height. Protruding from the plywood through the slot is a short dowel that helps keep the table level. -Dward Moore
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.